Tips on how to manage your PhD stipend FIND OUT MORE
University of Hong Kong Featured PhD Programmes
University of Sussex Featured PhD Programmes
University of Hull Featured PhD Programmes

PhD Discussion Forum

The following thread is brought to you by our sister Web site PostgraduateForum.com. If you wish to reply or post your own thread, you will be redirected to this site.

This Category:   PostgraduateForum.com > PhD Advice / Support


Message

Formatting thesis including published articles


User: SEM - 20 January 2021 05:48

I am pulling my thesis together, with 4 published chapters. The university says published papers should be included within the document, maintaining the formatting as they have been published. I have figured out how to do this two ways:

1) Convert the PDF to a Word document. This is much cleaner to read, but the sizing can be tricky to format into an A4 and, more critically, I have found that with at least one of my papers it messes up the scientific notations (They are basically free-floating around in the paper rather than staying within the sentence structure.)

2) Save each page of the article as its own PDF and then insert it into the Word document as an object, page by page. This is easier in terms of spacing and pagination, however the quality of the formatting is poor - it looks very fuzzy. I am worried when I convert it back to a PDF as a full document it will be even harder to read.

I have looked at other theses and their inserted papers look very clean and crisp. Does anyone have practical tips on how to maintain the quality and the formatting at the same time?

User: Jamie_Wizard - 20 January 2021 08:41

Yes. Use Latex!

User: Nead - 20 January 2021 09:26

First I would double-check what the mean my maintaining format- for my uni that just meant keeping the same heading and information etc
So I added in the word document that I would have sent to the journal for review -I didn't put in with two columns etc- I did change the referencing to match and on the title page foe reach chapter I wrote this paper title XXXX was published in XXX and gave the DOI and author list plus contributions.

The other option would be to save up as far as the first paper as a pdf, your pdf paper, then the next part as a pdf and merge all pdfs together or alternative leave blank pages for the pdf in word, print your thesis- on the pages for the pdf print the pdf on these pages, but the document back together and scan the completed version.

User: SEM - 29 January 2021 02:52

Thank you; those are very practical and helpful suggestions. I hadn't actually considered pulling the whole thing together as discrete PDF's which I think may work better all around, so I will experiment with that option first and go from there.

User: SEM - 29 January 2021 02:53

Eek! I think it's too late for that clever solution but maybe it will help some other poor soul.





FindAPhD. Copyright 2005-2021
All rights reserved.